Statesman Collection Doors
Go to the bottom of this page for Product Offerings and Availabilities. Below each color photograph are listed the Door Design, the minimum sizes, panel information and the Drawer Front name. The line drawing below each photograph shows a cross-section of the door.
Churchill
Min.: 8 7/8" w x 8 7/8"h
P-008 Raise Shown
2 3/4" Framing
Drawer Front: Churchill DF
Douglass
Min.: 8 7/8" w x 8 7/8"h
P-106 Raise Shown
Ogee Rails & Chamferred Stiles
2 3/4" Framing
Drawer Front: Douglass DF
Franklin
Min.: 8 7/8" w x 8 7/8"h
P-008 Raise Shown
2 3/4" Framing
Drawer Front: Franklin DF
Hancock
Min.: 9" w x 9"h
P-284 Raise Shown
2 3/4" Framing
Drawer Front: Hancock DF
Lafayette
Min.: 7 7/8" w x 7 5/8"h
Reverse G-Cove Raise Shown
G-056 Rout with 1 1/2" Spacing
2 3/4" Framing
Drawer Front: Lafayette DF
Monroe
Min.: 9" w x 9"h
P-284 Raise Shown
2 3/4" Framing
Drawer Front: Monroe DF
Product Offering and Availabilities:
  • Note:
    Framing widths on all designs are measured across the back of the framing.
    Unless otherwise specified, framing width on all designs is 2 3/4” measured across the back of the framing. 
    Minimums listed are based on raises shown.  
    Minimums will vary depending on panel raise selection.
  • Wood Species: All 3/4" species available.
  • Edge Profiles:  All 3/4" profiles available.
  • Framing Beads:
    Franklin, Churchill, Monroe, and Lafayette – all 3/4" framing beads available.
    Hancock and Douglass are standard as shown – no choices available.
  • Panel Raises:
    Franklin and Churchill – all 3/4" raises available.
    Hancock – P284, Presidential and Rev. G-Cove raises only.
    Monroe, Douglass, and Lafayette are standard as shown – no choices available.
  • Options:
    Franklin and Monroe - all available.
    Douglass, Churchill, and Honcock – all  except Camelot rout.
    Lafayette – all except G-012, G-015, and G-121 rout panel grooving.
  • Mullions: All available. Hancock and Douglass require special lite charge.
  • Appliance Panels: All available with apply over plywood or glue in strips only.