|
|||
Routed Finger and
|
|||
 |
||||||||
 |
||||||||
|
FP and CFP Edge Profiles The least expensive way to accomplish a “Finger Pull” profile is to request either the "FP" or "CFP" Edge Profile on the Wood Cabinet Door Order Form when ordering. This option is only available on all 4 sides of doors or drawer fronts (not one or two specific sides). FP Edges are available in 3/4" thickness only, and CPF Edges are available in 3/4" or 1" thickness. |
||||||||
|
|
||||||||
 |
||||||||
|
Back Routed Hand Pull Specify location: top or bottom and left, right or centered. Rout is 3-5/8” wide and 3/8” deep. When specifying left or right hand, pull will start 3” in from edge of door. Hand pull is centered on doors less than 10” wide. Available with all edge profiles without Rabbet except Bullnose, CFP, E-2, FP, L-253, L-686, LC-Inset, O and Sophisticate. |
||||||||
|
|
||||||||
 |
||||||||
|
Face Routed Hand Pull Specify location: top or bottom and left, right or centered. Rout is 4” wide and 1/2” deep. When specifying left or right hand, pull will start 3” in from edge of door. Hand pull is centered on doors less than 10” wide. Available with all edge profiles without Rabbet except Bullnose, CFP, E-2, FP, J-2, L-253, L-686, LC-Inset, O and Sophisticate. |
||||||||