|
|||
Special Frame Options |
|||
|
The following images show special options that are available on the face frame of each cabinet door.
Refer to the Product Offering and Availability options at the bottom of each door design page to see if these options are available on your door design. |
|||||||||||||||
 |
|||||||||||||||
|
5/16” Square Pegs Specify quantity, location and species. If location is not specified, pegs will be located 1-3/16” from inside of framing bead to center of peg. All species available. |
|||||||||||||||
|
|
|||||||||||||||
 |
|||||||||||||||
|
1/2” Round Pegs Specify quantity, location and species. If location is not specified, pegs will be located 1-3/16” from inside of framing bead to center of peg. Pegs available in Red Oak, Cherry, Walnut or Hard Maple. |
|||||||||||||||
|
|
|||||||||||||||
 |
|||||||||||||||
|
Radius Corners Specify 1/8”, 1/4", 1/2”, or 1” radius. Available with B-2, C-2, H-2, LC-2, L-059,O, L-149, Machine Edge, PRS-2 and V-2 edge profiles only. |
|||||||||||||||
|
|
|||||||||||||||
 |
|||||||||||||||
|
Putty Pin Holes
|
|||||||||||||||
| Pin Holes are visible on the back of all mortise and tenon doors. Pin holes (holes created by nail brads that secure and reinforce the mortise and tenon jointery) will not be puttied / filled unless specified when ordering. There is a small upcharge for this service. | |||||||||||||||